Water requirements of early-maturing rice varieties

THE PRODUCTION of farmers whose areas are troubled by drought or insufficient water supply will be greatly affected.

Because of the problem, farmers with insufficient water supply are advised to adopt early-maturing varieties or with maturity days less than 110 this coming dry season.

Early-maturing varieties require lesser water, as they can mature faster than other inbred varieties, says Philippine Rice Research Institute’s (PhilRice’s) in-house agriculturist and Text Center lead agent Fredierick M. Saludez.

A rice crop that matures in 100 days will require approximately 1,000-mm of water while a crop that matures in 150 days will require 50 percent more.

For rainfed and irrigated areas, using these varieties will reduce the water needed and the number of days in supplying water.

Farmers in irrigated areas are recommended to plant the following varieties, include PSB Rc 4 (Molawin), Rc 8 (Talavera), Rc 10 (Pagsanjan), Rc 82 (Peñaranda), NSIC Rc 118 (Matatag 3), Rc 120 (Matatag 6), Rc 130 (Tubigan 3), Rc 134 (Tubigan 4), Rc 140 (Tubigan 6), Rc 144 (Tubigan 8), Rc 146 (PJ7), Rc 148 (Mabango 2), Rc 152 (Tubigan 10), Rc 154 (Tubigan 11), Rc 238 (Tubigan 21), Rc 242 (Japonica 2), Rc436 (Tubigan 37), Rc 438 (Tubigan 38), and Rc 440 (Tubigan 39).

While the PSB Rc 12 (Caliraya), Rc 14(Rio Grande), and NSIC Rc 192(Sahod Ulan 1) are suitable in rainfed areas.

Average yield of these varieties ranges from 4 to 10 tons per hectare.

They mature between 105 and 110 days compared with 115-125 days for other varieties.

Reduction in yield happens when rice plants are exposed to various stresses like drought, especially during the flowering stage.

With the early-maturing varieties, this is less likely to happen.

A series of studies from the PhilRice’s Plant Breeding and Biotechnology Division showed an average of 64 percent yield reduction, under drought condition, during dry season from 2015 to 2018.

PhilRice also recommended water-saving technologies, such as the alternate-wetting, and drying (AWD).

AWD is a water-saving technology that reduces the use of irrigation water without penalizing crop yield.

Based on studies, rice farmers in lowland areas can save water by up to 50 percent, if properly implemented.

Locally available materials such as bamboo or PVC tubes with 4 inch diameter and 25-cm in length are used to install AWD.

A farmer from Masinloc, Zambales testified that the AWD is an effective, as it helped him save water in irrigating his farm.

It was learned that he used to irrigate his area twice a week.

But with the AWD, he found out that he can just pump water once a week.

Technology promoters advised that farmers should also put holes (3-5mm) to serve as a water passage, around the tube with 5cm distance.

This will be inserted into the soil up to the 15cm marked for dry season and 20cm marked for wet season.

The researchers said that farmers will just have to wait until the water subsides down to the bottom of the tube before the next irrigation./PN

LEAVE A REPLY

Please enter your comment!
Please enter your name here